CANOGA PERKINS 9145E Network Interface Device - Manual (Page 34)

9145E Ethernet Network Interface Device User’s Manual Installation
Installing the SFP Modules
22
3.4 Installing the SFP Modules
1. Determine which SFP Module(s) is/are required for the User, Network, and Multipurpose
ports by referencing the SFP Product Data Sheet.
2. Insert a module into each available port and push firmly to seat module (see Figure 3-10).
3. Raise latch to lock module in place.
Figure 3-10. SFP Modules
3.5 Connecting the Electrical Power
NOTE: When power is applied, all LED indicators will light amber.
3.5.1 AC Power
NOTE: Country specific power cords are available locally for installations
outside of North America
The 9145E uses a standard IEC320 AC Power Connector. Plug the AC power cord into the
socket at the rear of the 9145E and plug the other end of the AC power cord into a convenient AC
outlet.