Dynon Avionics EFIS-D100 Installation Guide - Manual (Page 103)

Appendix
EFIS-D100 Installation Guide 7-35
Appendix F: Replacing the EFIS-D100 battery pack
1. e the two screws (either #1 Phillips or 7/64” hex, depending on when your unit
was manu ll r on t IS-
D100. Remo or. D screw of the
unit.
2. If you previously had a battery, disconnect it from the EFIS-D100 by unplugging the
battery connector and gently pulling out old battery. It is safe to gently pull on the battery
wire to remove the battery.
3. Insert the new battery with the bumpy side up.
4. Connect the battery connector to the battery. The connector is keyed; make sure it is
positioned correctly.
5. Position the connector so it is centered on the end of the pack. Verify that the battery
pack will not interfere with insertion of either of the door screws.
6. Reinsert screws and tighten to 12 in-lbs.
Appendix G: Weights
Adding any new instrument to an aircraft requires the installer to be aware of its weight and how
that affects the overall weight and balance of the plane. The following are the weights of the
EFIS-D100 and associated Dynon-supplied sensors.
Installed EFIS-D100 .....................................................................................2 lb 13.5 oz (1.287 kg)
EFIS-D100 + battery..........................................................................................3 lb 4 oz (1.465 kg)
EFIS 25-pin wiring harness
11.2 oz (0.32 kg)
r Controller ......................................................11.2 oz (0.32 kg)
Unheated AOA/Pitot Probe......................................................................................5.6 oz (0.16 kg)
Remov
factured) from the sma
ve the battery do
, rectangular battery doo
o not remove any other
he side of the EF
s from the case
...................................................................................
EDC-D10A ............................................................................................................3.6 oz (0.102 kg)
EFIS OAT ................................................................................................................3.2 oz (0.08 kg)
Heated AOA/Pitot Probe & Heate