Leica Geosystems Leica DISTO D3a - User Manual - Manual (Page 17)

16 Functions Leica DISTO™ D3a 776175a gb
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
H
RUS
CZ
Stake out function
Two different distances (a and b) can be entered into
the instrument and can then be used to mark off
defined measured lengths, e.g. in the construction of
wooden frames.
Entering stake out distances:
Press this button three times and the stake out
function symbol appears in the display .
The value (a) and the corresponding intermediate line
flash.
By using and , you can adjust the values
(first a and then b) to suit the desired stake out
distances. Holding the buttons down increases the
rate of change of the values.
Once the desired value (a) has been reached it can be
confirmed with the
button.
The value (b) and the intermediate line flashes (the
defined value (a) is automatically adopted). Value (b)
can be entered using
and .
The defined value (b) is confirmed with the
button.
Pressing the button starts the laser measure-
ment. The display shows required stake out distance
in the summary line between the stake out point
(first a and then b) and the instrument (rear refer-
ence).
If the DISTO™ is then moved slowly along the stake
out line the displayed distance decreases. The instru-
ment starts to beep at a distance of 0.1m from the
next stake out point.
The arrows in the display indicate in which direc-
tion the DISTO™ needs to be moved in order to
achieve the defined distance (either a or b). As soon
as the stake out point is reached the beep changes
and the intermediate line starts to flash.
The function can be stopped at any time by pressing
the
button.
11
2
3
0.625 m
0.625 m
0.625 m
0.625 m
0.625 m
1.025 m
a
b
b
a
b
b