Leica Geosystems Leica DISTO D810 touch - Manual - Manual (Page 25)

Leica DISTO TM D810 touch 799093a 24
EN Functions
Compass
1 2
Calibrate
Compass?
Refuse Confirm
0.0°N
The
arrow
always
points to
true
north.
3
Check that mul-
tifunctional end-
piece is not
folded out.
Keep the device
away from any
magnet.
4
Exit.
5
i
At the following places the compass
probably does not work correctly:
• Inside of buildings
• Close to high voltage lines (e.g. on
train platforms)
• Close to magnets, metal objects or
electrical household appliances
i
If an error mes-
sage occurs, the
device is tilted
too much
(>20° over the
front / > 10°
sidewise).
Calibration of Compass:
i
The compass
has to be cali-
brated before
every first
measurement
after switching
on the device.
Rotate the device slowly in a figure 8 motion until OK
icon appears on the display.
i
After 2 sec the
device goes
back to the
compass mode.