Leica Geosystems Leica Racer 100 - Manual (Page 15)

10 Functions Leica Racer 100 784117 en
EN
D
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
H
RUS
CZ
Volume
Press this button twice. The symbol
appears in the display.
Press this button to take the first length
measurement (e.g. length).
Press this button to take the second length
measurement (e.g. width).
Press this button to take the third length measure-
ment (e.g. height).
The volume then appears in the summary line.
Press the button for longer to display additional
room information such as ceiling/floor area, surface
area of the walls, circumference.
Tilt measurement
)
The inclination sensor measures tilts between
± 45°.
)
During tilt measurement the instrument
should be hold without a transverse tilt (± 10°).
Press this button once to activate the tilt
sensor. The symbol appears in the display. The
tilt is continuously shown as ° or % depending on the
setting.
Press to measure the inclination and the
distance. See figure {J}.
Direct horizontal distance
Press this button twice and the following
symbol appears in the display .
Press this button to measure tilt and distance.
The summary line displays the result as the direct
horizontal distance.
Room corner angle function
The angles in a triangle can be calculated by measuring
the three sides. This function can be used e. g. to
check a right-angled room corner. See figure {K}.
Press this button three times and the room
corner symbol appears in the display .
Mark the reference points to the right and left (d1/
d2) of the angle to be measured.
Press this button to measure the first (short)
side of the triangle (d1 or d2).
Press this button to measure the second (short)
side of the triangle (d1 or d2).
Press this button to measure the third (long)
side of the triangle (d3).
The result is displayed in the summary line as the
room corner angle.