Troubleshooting, The power does not turn on, As the power is turned on, it – Panasonic DMC-LC43A User Manual
Page 93: The image cannot be recorded, 4; the image is not displayed on the lcd monitor, The lcd monitor is too bright, Flash does not light, The display or images on the, The image will not play back, The clock setting is reset
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Others
Troubleshooting
1:
The power does not turn on.
1
-
1
; Are the batteries inserted? Check
whether the batteries are
inserted.
1- 2: Is the battery power sufficient?
Use a battery that has been
sufficiently charged.
2:
As the power is turned on, it
turns off immediateiy.
2
-
1
; Is the battery power insufficient to
operate the camera? Charge the
battery or replace it with charged
one.
2- 2: Is the batteries other than the
recommended ones used?
3:
The image cannot be recorded.
3- 1: Is the Memory Card inside?
3-2:
is the mode dial correctly set?
Check it.
3- 3: There is no memory capacity left
on the card. Before recording,
delete some images.
4; The image is not displayed on
the LCD monitor.
4- 1: Is the LCD monitor set to OFF?
4-2:
Does the economy mode work?
5:
The LCD monitor is too bright
or dark.
5:
Adjust the brightness of the LCD
monitor.
6:
Flash does not light.
6
:
The flash mode is set to forced
OFF, Change the flash mode.
7:
The display or images on the
LCD monitor are not focused.
7:
Set the mode dial to the mode
corresponding to the distance to
the subject.
8
:
8
-
1
:
8
-
2
:
8- 3:
9:
9- 1:
9-2:
10
:
The image will not play back.
Is the Memory Card inside?
There is no image in the Memory
Card.
The mode dial is not set to
playback [[Q].
The Image is not displayed on
the television.
Is the camera correctly
connected with the TV? Check it.
Set the TV to video input mode.
When connecting to a PC,
images cannot be transferred.
10
-
1
: Check that the camera is
correctly connected to the PC.
10- 2: Is the camera correctly
recognized by the PC?
11:
The clock setting is reset.
11- 1: If you do not use the camera for a
long time, the clock setting may
be reset. When the message
[PLEASE SET THE CLOCK]
appears, set the clock again.
11
-
2
; When you take a picture before
setting the clock, [
0:00
0
.
0
.
0
] is
recorded.
12:
When you rotate the zoom
lever from T to W, and then
release it, the image may
appear closer for a moment
again and the camera may
vibrate.
12; This is the operation for keeping
the focus accuracy. However, this
is not malfunction.
13:
Noise appears on the LCD
monitor.
13:
In dark places, noise may appear
to maintain the brightness of the
LCD monitor. This does not affect
the images you are recording.
93