Panasonic PV-V4520 - Manual (Page 18)

Multi-Brand Control Feature
The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Multi-Brand Control Setup
1
Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
2 Setup for TV
GD GD CZ)
. GD GD CD
and
<D CD
CD
Setup for Cable or DSS
O CD QD
A
tCABLE^
. QD QD QD
and
CD CD CD
CD
Set up remote.
Hold down TV and enter code
with NUMBERED keys.
Hold down DSS/CABLE and
enter code with NUMBERED keys.
• For rnrifi inn nr nroster, press the
100 key first, then remaining digit.
E.g. for 102, press 100, then press 0,
and then press
2 .
Confirm code entry.
Press POWER to turn selected
unit ON or OFF.
• See table below for list of
controllable functions in each mode.
Please repeat Multi-Brand Control setup after replacing remote
control batteries.
The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
3
POWER
P TVor
DSS/ CABLE
Q NUMBERED
^ keys
Model PV-V4520 remote is shown here.
Using the Multi-Brand Control
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
Mode^'^Byttora
VCR TV CABLE/ DSS
VCR All Functions VOL UP/DOWN
TV
VCR/rV, PLAY, STOP
EJECT, SAP/Hi-Fi (PV-
V4520only), DISPLAY,
FF,REW,PAUSE/SLOW,
REC, SPEED, COUNTER
RESET, TAPE POSITION,
CM SKIP
POWER, INPUT,
NUMBERED keys,
ENTER, CH UP/ DOWN,
VOL UP/DOWN
CABLE/ DSS
VCR/TV, PLAY, STOP
EJECT, SAP/Hi-Fi(PV-
V4520only), DISPLAY,
FF,REW,PAUSE/SLOW.
REC, SPEED, COUNTER
RESET, TAPE POSITION,
CM SKIP
VOL UP/ DOWN POWER, ENTER.
NUMBERED keys
{except lOOkey),
CH UP/ DOWN
In TV or DSS/ CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
18
For assistance, call 1-800-211-PANA(7262).