Power source for the infra-red remote controller – Panasonic NV-G21 User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

O VTR On/Off Switch

For turning the VTR on and off.

^ Programme Position (Channei) Selector Buttons

O Record Buttons (•)

To start recording, press the both buttons simul­
taneously.

O Pause/Still Button (II)

0 Stop Button (■)

0 Rewind '4'4/Review @ Button

When this button is kept pressed during playback, the
VTR changes over to the Review playback mode.

O Play Button (^}

O Slow Button (!•-)

Press the Slow Button for slow-motion playback at Vio

of normal speed. The stow playback speed can be
varied between

V

25

and Vs of normal speed by using

the and Buttons.

Note:

If the VTR is left in the slow playback mode for more
than 5 minutes, the VTR will automatically switch over

to the stop mode, to protect the tape and the video

heads.
•Adjust the Slow Tracking Control if necessary.

© Double Speed Playback Button (X2)

<D Fast Forward ^^/Cue @ Button

When this button is kept pressed during playback, the
VTR changes over to the Cue playback mode.

Still Advance button (!!►)

VTR/TV Selector

(D

0

Power Source for the Infra-red Remote

Controller

■ The Infra-red Remote Controller is powered by two I EC

“R6” size batteries. The life of the batteries is about one

year, however, it depends on the frequency of use.

Inspect and if necessary, replace the batteries once a
year.

CAUTION FOR BATTERY REPLACEMENT

•Load the new batteries with their polarities (0 and ©)

aligned correctly.

•Do not apply heat to batteries, or internal short-circuit may

occur.

•If you do not intend to use the Remote Controller for a long

period of time, remove the batteries and store them in a
cool and dry place.

•Remove spent batteries immediately and dispose of them.

•Do not use an old and a new batteries together. (Also

never use an alkaline battery with a manganese battery.)

Load the batteries as follows:

O Remove the battery com­

partment lid.

© Place two batteries in the

battery compartment as
indicated inside the bat­
tery compartment.

o Replace the lid.

•The infra-red beam should be transmitted directly at the

Infra-red Remote Control Receiver on the front of the

VTR.

•Direct sunlight may interfere with the beam.
•The iightsensing angle of the Infra-red Remote Control

Receiver window in the VTR is about 60°.

•The unit should be used within a range of about 7 meters

Advertising