2. vs gen-lock mode (ext(vs)), 3. line-lock sync mode (ll) – Panasonic WV-CPR650 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6-2. VS Gen-lock Mode (EXT(VS))
1. Move the cursor to the SYNC parameter and
select INT.
2. Connect the coaxial cable for the composite sync
or composite BM video signal to the gen-lock
input connector.
3. Confirm that the parameter INT changed to EXT
(VS) on the menu.
Caution: The gen-lock input signal should meet
with EIA RS-170 specifications and should not
contain jitter, such as a VCR playback signal ,
as it could disturb synchronization.
X------------
—^
r
** CAM SET UP • *
•• CAM SET UP **
СЛМЕЯЛ ID
OFF “1
CAMERA ID
OFF 1
АЬС/ЕЬС
ALC
A1<C/BLC
ALC 1
SHUTTER
—
SHUTTER
- - -
лес
ON
L
AGC
ON
SENS UP
OFF
4
SENS UP
OFF
SYNC
^XOT.
SYNC
EXT (VS)
WHITE BAl.
ATW “1
WHITE HAL
ATW
MOTION OBT
OFF
MOTION DBT
OFF ~]
LENS DRIVE
DC
lens
drive
DC
^ RET
^ RET
>
After confirming the cursor is on EXT (VS), press
El ■ The phase adjustment menu appears on the
monitor.
f
---- Ч
* * SYNC •*
В PHASE
RET END
V________
J
5. Move the cursor to H PHASE. The cursor starts
blinking.
6. Supply the video output signal of the camera to be
adjusted and the reference gen-tock input signal
to a dual-trace oscilloscope.
7. Set the oscilloscope to the horizontal rate and
expand the horizontal sync portion on the oscillo
scope.
8. Adjust the horizontal phase by pressing €1 or
. The adjustable range is 0 - 2.Ops.
6-3. Line-lock Sync Mode (LL)
Note: The line-lock (LL) sync mode is not available
when the camera operates on DC power.
1. Move the cursor to the SYNC parameter and
select LL.
Note: The settings in this menu can be made only
when the multiplexed vertical drive signal
(VD2) is not supplied to the camera.
-32-