Panasonic EP3203 - Manual (Page 25)

4. When you want to customize your massage even more.
You can adjust the height and lateral movement of the massage heads, as well as the speed and strength
of the massage.
Adjusting Massage Position
position
Press (:>■■< -
Adjusting Massage Speed
tack speed
Press II.
Adjusting Massage Strength
back
Press B.
Adjusting Lateral Movement
lateral
Press
Press the button as many times as you like in any direction to move the massage
heads to the position you require.
Each time you press the button the massage heads move approximately 11/16"
(1.8 cm) up or down and approximately 1/4" (0.6 cm) left or right.
If you hold the up or down button down the massage heads will continue to move until
you release the button.
When the massage heads have been moved as far as possible you will hear a "peep-
peep-peep" sound.
In some places the strength of the massage will be automatically reduced.
The approximate position of the massage will be shown on the display.
In some cases the massage action will not immediately change even though the
massage action button is pressed.
You can press the button as many times as you like to increase or decrease the speed
of the massage.
When the speed of the massage has been increased or decreased as much as
possible you will hear a “beep-beep-beep” sound.
It is not possible to adjust Shiatsu C.
The speed of the massage is shown on the Massage Action Display in five stages.
You can press the button as many times as you like to increase or decrease the
strength of the massage.
When the strength of the massage has been increased or decreased as much as
possible you will hear a “beep-beep-beep” sound.
In some places the strength of the massage will not be able to reach the maximum
level of 5.
The strength of the massage is shown on the Massage Action Display in five stages.
Shiatsu C can be adjusted in five stages.
In some cases the massage action will not immediately change even though the
massage action button is pressed.
Press this button to increase the width of the massage in the location the
massage heads were in when you pressed the button.
<=) will be shown on the display.
In some places the strength of the massage will be automatically reduced.
Press the button again to revert to normal massage action.
After the massage has been completed the unit will automatically stop.
• The unit will automatically stop approximately 15 minutes after the massage begins.
• If you want to continue using the massage lounger then we recommend that you wait at least 10 minutes in between each
massage. _
• If you want to stop the massage during a program press @. Press ® if you want to stop the massage immediately.
• When stopping the massage when using Shiatsu C or Roll, the voice navigation will provide an explanation of the User
Program function and B wiH flash. In this case, if you press one of the User Memory Buttons only body searching data
will be saved, (i.e. Details regarding the Manual Operation will not be saved.)
Massage Actions (Upper Body)
shiatsuA Shiatsu: This feels as though the thumbs of both hands are being
m used to work on the acupressure points. The initial strong push is
followed by a short pause to give the impression of a professional
Shiatsu massage therapist.
Shiatsu B
kneadA
knead B
kneadC
Swedish
3-Stage Shiatsu; This massage features three inoreasingly strong
pushes.
Pressing; This massage presses stiff muscles toward the outside
and is effective on areas around the shoulder blades on the outer
shoulders as well as the lower baok.
Kneading; With this massage, a strong push is followed by a quiok
release in a rhyfhm that is designed to relax stiff muscles. It is ideal
for loosening stiff muscles in the neck and beside the spine.
Deep Kneading; With this massage the massage heads work slowly
over the acupressure points in a deep kneading motion.
Wide Kneading: This motion is like the palms of both hands being
used to press and rub over a wide area from both sides of the body.
This type of massage is ideal for someone wanting a broad Swedish
style massage on the back or lower back.
lap A
tapB
tape
roll
regional
Tapping: This motion is like a fist used in a rhythmic pattern to
provide a solid tapping that is designed to eliminate stubborn
stiffness and tiredness.
Soft Tapping; With this massage soft tapping is oarried out in a
rhythmio pattern alternately to the left and right.
Rhythmic Tapping: With this massage slow tapping is alternated
with light tapping to relax stiff musoles.
Rolling: The massage heads become rollers that roll over the back
up and down from the neck to the lower back to stretch the back
musoles and relieve tension.
Regional Rolling: The massage heads become rollers that roll over
the back muscles, but this time in a specified 4 in. location.
shiatsuC
IS
vibration
Pressing: With this massage the shoulder muscles are pressed down
from directly above to bring relief to stiff muscles.
Vibration; The high frequency vibration action helps your tense body
to relax. This is ideal when used together with rolling, etc. for a full
body massage. (EP3203 only)
23