Panasonic PV C2063 - Manual (Page 32)

üaDie BOX universal Kemote uontroi reature
Universal Remote Control Is...
The Remote Control may be set up to control some basic
DSS or Cable box tunctions.
The Universal Remote Control Setup
1
Find your DSS box or Cable box Brand Code
Number from one of the charts on the next
page.
Setup remote. Hold down DSS CABLE and
press number keys
to enter code.
• For code too or greater, first press 100 key, then the
remaining digits. E.g. for 102, press 100, then press 0, and
then press 2.
Confirm code entry. Press POWER to turn
selected unit ON or OFF.
• See below for oontroilable functions in each mode.
■ Please repeat the Universal Remote Control Setup after
replacing remote control batteries.
■ The remote control will not operate all DSS receivers or Cable
Boxes made by the manufactures listed. If you get no results,
your particular brand cannot be controlled.
Using the Universal Remote Control
Once the remote control has beers properly set up, you cars
select COMBO. DSS or CABLE mode depending on which
functions you wish to control. (See below.)
Press COMBO or DSS CABLE on the remote control
to select the desired mode. (See below for buttons
available in each mode.)
Set to COMBO:
• All TV and VCR functions.
Set to DSS CABLE:
• Basso VCR functions, e.g. PLAY, REC, etc.
• CABLE/DSS functions, e.g. POWER, ENTER, number keys
(except too key), CH UP/DOWN.
POWER
COMBO
DSS/CABLE
-NUMBER Keys
-ENTER
32 For assistance, please call: 1 -800-211 -PANA(7262) or send e-mail to : consumerproducts© panasonic.com