Panasonic DVDXV10 - Manual (Page 19)

Sound Page
No sound. •Check the connections. 4,5
Distorted sound. •Check the volume on the equipment you have connected. -
•Ensure that the input settings for the television and stereo system are correct. -
•Turn ADVANCED SURROUND off if it causes distortion. 13
Piercing noise comes from the •}f you have connected this unit to other equipment through the DiGfTAL AUDIO OUT terminaf, 17
speakers. ensure you have selected the correct settings for “Dolby Oigitar. “DTS Digitai Surround" and
“MPEG'" in the SETUP menu’s Audio menu.
•Not available in Asia.
Unit displays
“NO PLAY" •You inserted a disc the unit cannot play; insert one it can. 7
“CHECK msc"
•Disc is dirty. Wipe the disc dean. -
“HOn" •Trouble is likely to have occurred. The number following “H" depends on the status of the unit.
-
□1] stands for a number. Reset procedure:
Press [t!j] to switch the unit to the standby mode and then back to ON. Alternatively, press
[O
j ] to switch the unit to the standby mode, disconnect the AC mains lead, and then reconnect it.
• If the service numbers fail to clear, note the service number and contact a qualified service
person.
“NO DtSC” •You haven’t inserted a disc; insert one.
-
•You haven’t inserted the disc correctly; insert it correctly. 8
Television displays
No on-screen display. •Go to Display in the SETUP menus, and select “On" for “On-Screen Messages”. 16
GUI screens not displayed or •Press [A, T] while the rightmost icon is highlighted to move them. 14
only partially displayed on the
television.
The disc’s menu is displayed in •Go to Disc in the SETUP menus, and select the preferred language for “Menus”, 16
a different language. «)
O
c
s
0)
oc
Safety precautions
Placement Service
Set the unit up on an even surface away from direct sunlight, high tem­
peratures, high humidity, and excessive vibration. These conditions can
damage the cabinet and other components, thereby shortening the unit’s
service life.
Do not place heavy items on the unit.
Voltage
Do not use high voltage power sources. This can overload the unit and
cause a lire.
Do not use a DC power source. Check the source carefully when setting
the unit up on a ship or other place where DC is used.
Do not attempt to repair this unit by yourself. If sound is interrupted, indi­
cators fail to light, smoke appears, or any other problem that is not covered
in these instructions occurs, disconnect the AC mains lead and contact
your dealer or an authorized service center. Electric shock or damage to
the unit can occur if the unit is repaired, disassembled or reconstructed by
unqualified persons.
Extend operating life by disconnecting the unit from the power source if it
is not to be used for a long time.
AC mains lead protection
Ensure the AC mains lead is connected correctly and not damaged.
Poor connection and lead damage can cause fire or electric shock. Do not
pull, bend, or place heavy items on the lead.
Grasp the plug firmly when unplugging the lead. Pulling the AC mains
lead can cause electric shock.
Do not handle the plug with wet hands. This can cause electric shock.
Foreign matter
Do not let metal objects fall inside the unit. This can cause electric shock
or malfunction.
Do not let liquids get into the unit. This can cause electric shock or mal­
function. If this occurs, immediately disconnect the unit from the power
supply and contact your dealer.
Do not spray insecticides onto or into the unit. They contain flammable
gases which can ignite if sprayed into the unit.
Do not place the unit
on amplifiers or equip-
ment that may become
hot
The heat can damage the unit.
Maintenance
Clean this unit with the included cleaning cloth.
• Never use alcohol, paint thinner or benzine to dean this unit.