Note, I note, 0 press [e] to exit command reference – Panasonic KX-P 1131 User Manual
Page 27: Using the software, Command reference program, Wincjows, Windows 95 and, Windows 98
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the Software
Command Reference Program
The Command Reference program allows you to access a detailed explanation of each software command on the
screen. Each displayed explanation can be printed out if required.
Note:
• You can print the Character Set Tables. On the SELECT COMMAND screen, press [C]. Then select your
desired table and press [ Enter ].
• If 7 bit is selected for Data Length, you cannot print the command lists and character set tables.
• There is a list of Proportional Spacing Tables after the software commands lists. If you want to see a
proportional spacing table, select your desired table and press [ Enter].
To recall the programs, follow the steps below.
<DOS>
<WincJows
3.1 >
<Windows 95 and
V
At your C:\prompt,
1
Select
1
Run] from the File
Windows 98>
type
CD
PI 131 and press
menu.
-f
Click
j
Start i, point to
[Enter].
“Run...” and click.
2
Type
C:\P1131\CMDREF
2
Type
C:\P1131\CMDREF
2
Type
CMDREF
and press
and press [Enter].
and press
[
Enter
]
[
Enter].
(or click lOK
1
).
(or click
[^).
* If you changed the directory when installing utilities for DOS, select your changed directory and press [ Enter ].
i Note:
I • If you want to run the Command Referece program using the Setup Disk, follow the steps below.
1. Insert your DOS Utilités & Printer Driver for Windows® 3.1,95 & 98 disk into drive A (or B).
<DOS>
<Windows 3.1>
<Windows 95 and Windows 98>
0
Type A: (or B:) and press
2.
O
Select
1 Run 1
from the File
2.
O
Click
1 Start 1
. point to
[ Enter].
menu.
“Run...”
and click.
0 Type CD DOS and press
© Type A:\DOS\CMDREF
© Type A:\DOS\CMDREF
[ Enter].
(or B:\DOS\CMDREF).
(or B:\DOS\CMDREF).
© Click
© Click
IWl
© Type CMDREF and press
(Enter).
(or press
Tenter)).
(or press
(Enter]).
The first screen is an introduction to
the operation of the Command Reference
program. Please read it through and press
any key to continue. (If your display is
monochrome, press “M” key.)
Select the desired emulation and press
[ Enter ] (or click fOKl).
The commands list will be displayed.
Select the desired command and press
[ Enter ] (or click | OK \).
The detailed explanation of the command will be
displayed.
« Panasonic KX-P1131 command reference utility (xxxxxxxxxx) »
--SELECTEMULATION --
EPSON
IBM
[îl/[^]
[Enter]
{E]
Select emulation
Set emulation
Exit Command Reference
(0
u
5'
(Q
0)
3
a
c
Î2.
5*
(D
(D
X
I
■a
CO
CO
o
0)
<D
0
Press [
e
] to exit Command Reference.
27