Initial setup mode, Using the control panel – Panasonic KX-P 1131 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the Control Panel
Initial Setup Mode
The 19 features (items) can be set in the Initial Setup mode through the Control Panel. For the features and the
indicators condition, refer to page 33. These features can also be set through the Control Panel Software program
{P, 24).
1
2
Load a sheet of paper (
b
$" P. 13-16), and
turn the power off.
While pressing [LOAD/PARK] , turn the
power on to enter the Initial Setup mode.
Both FONT indicators and the HIGH SPEED
indicator will be blinking.
The current settings will be printed
automatically.
Press and release [^ITCH) to set the item’s
status.
The item’s status will change each time you
press [PITCH] {US’ P. 33).
To change additional settings, repeat step 3 and
4.
5 Press [ LOAD/PARK] to exit the Initial Setup
mode,
FONT indicator will go off and the current
conditions will print.
Press and release [FONT] and [ON LINE)
to select the item.
Each time you press [ FONT] and [ON LINE ],
you will advance to the next item. Select the
desired item according to the status of the FONT
and ON LINE indicators (on, off, blinking)
(c^ P- 33).
Note:
•To return all current settings to the factory
settings, follow the steps below.
1. While pressing [HoXo/PARK], turn the
power on, then release.
2. Press [ TEAR OFF ].
3. Press [ LOAD/PARK] to exit the Initial Setup
mode.
32