Panasonic SX-MB100 - Manual (Page 27)

F№l MODE
Use this mode to reduce spurious noise in the FM stereo
broadcasts.
■ Press the FM MODE button.
O
LOW CUT
/FMUOOE
Monaural indication
The sound changes to monaurai output, but spurious
noise is reduced, making the radio station easier to
iisten to.
Exit the FM MODE by pressing the button again. (This
is the normai setting for this button.)
Station settings cannot be stored as presets when the
monaural status is active.
Changing the tuning intepval
The tuning frequency intervai can be changed from 0.1
MHz to 0.2 MHz, and vice versa.
=> Press and hoid the FM TUNER button (about 10 sec­
onds).
• After about 5 seconds, 87.9/87.50 wiil flash on the
display. If you continue to press and hold the button,
after about 10 seconds the indication will change to
87.50/87.9 and the operation to change the tuning
frequency interval is complete. If you release the but­
ton before this indication appears, the frequency step
remains unchanged.
• You can repeat this procedure to return to the original
setting,
• Note that this procedure will erase the preset channel
memories.
Other Settings
Various menu functions enhance the capabilities of your instrument.
« This operation is not available in the FM TUNER or BEAT MASTER mode.
^ \ 1 ^ o
—JJ o
COo O oo O
Outline of the ppocedure
1. Press the MENU button to turn it on.
--------- SOUND / RHYTHM SELECT ---------
MENU
oooo
o O 6 6 6
s “ i b 6 6 6
2.Use the number buttons to enter the menu number for
the function you wish to set (2 digits).
• The + and - buttons can also be used to specify the
menu number.
■ Menu list
01: RHY&PAD VOL
Overall volume setting for the automatic accom­
paniment and pads.
02: PART VOLUME
Adjust the volume of each part.
03: PART SOUND
Adjust the sound for each part.
04: PART PANPOT
Adjust the stereo balance of each part.
05: SPLIT POINT
Change the keyboard split point.
06; TEMPO DETECT
Specify whether or not CD tempo detect func­
tions each time the song changes.
07: FOOT SWITCH
Assign a function to the Foot Switch (separately
sold option).
08: LCD CONTRAST
Adjust the readability of the display.
09: LIGHT SHOW
Specify whether or not the light show (indicators
flicker when this instrument has been silent for a
while) is enabled.
10: ALL INITIAL
Return all the instrument functions and settings
to their factory-preset status.
(Continued on the next page)
27
QQTG0626