Panasonic SC-CH60 - Manual (Page 7)

For best reception and sound quality, use an
FM outdoor antenna (not included).
If you use an FM outdoor antenna, disconnect the indoor an­
tenna.
You may need an outdoor antenna if you use this system in a
mountainous region or inside a reinforced-concrete building, etc.
An outdoor antenna should be installed by a competent techni­
cian only.
Connecting a 75-ohm coaxial cable
Connect an external unit, such as audio tape
deck (for playback only) or output terminals of
a VCR or TV (not included).
Connecting external unit
3
Connect the included AM loop antenna.
Connect the AM loop antenna to the AM antenna terminal.
You may attach the AM antenna holder to the rear panel of the
system or to a rack or other structure.
Clamp the antenna to the holder and position the loop for the
best reception.
To minimize noise pickup, keep the loop antenna away from the
speaker cable, power cord, flat cable, and metal surfaces.
Connecting an AM outdoor antenna (not included)
You may need an outdoor antenna if you use this system in a
mountainous region or inside a reinforced-concrete building, etc.
Run vinyl-covered wire of 5-12 m horizontally along the window
or some other convenient location.
5 - 1 2 m
AM EXT ANT
------- AUX---------
B 0 0
------- 0 L /AUDIO n
=an[i./““7 Ninii>=(R) ------- O R ^OUT J
•-CZZl-------------------------------------- —
Stereo connection cable
(not included) Video cassette recorder
(not included)
Connect the right (R) and left (L) speaker
cables.
Match the two wires from the left and right speaker cables with
the same colored levers of the speaker terminals, then insert the
wires into the respective terminals.
Connection of speaker cables
1 . strip off the outer
covering, and twist the
center conductor.
Make sure the bare ends of the wires are not unraveled.
(If they are, twist them tight again.)
2 . Insert the wire to the
rear panel of the main
unit, and then close
the lever.
Notes;
Connect speaker cables before connecting the AC power
supply.
Be sure to connect only positive (red) wires to positive (+)
terminals and negative (black) wires to negative (-) terminals'.
To prevent damage to circuitry, never short-circuit positive (-(-)
and negative (-) speaker wires.
AM outdoor antenna (not included)
Connect the AC power supply cord after you
have connected all other cables and cords.
Press the MAIN POWER switch to ON position.
The primary circuit is always “live" as long as this switch is set
to ON position.
Note;
If you don’t plan to use the system for a long time, press the
MAIN POWER switch to OFF position or disconnect the AC
power supply cord.