Panasonic SC-AK57 - Manual (Page 23)

I
(D Recording
Before recording (Deck 2 only)
Types of tapes which can record correctly
The unit automatically identifies the type of tape.
NORMAL POSiTIONn'YPE 1 0
HIGH POSITIONrrYPE 11 0
METAL POSITION/TYPE IV X
This system cannot make a recording or erasing correctly, if metal
position tapes are used.
To record from the beginning of the tape El
You cannot record o n the leader part of the tape. Before recording,
wind the tape past the leader to a point where recording can start
immediately.
To start recording from a particular position
on the tope
Wind the tape on to the position you want recording to start from.
To start recording from the reverse side SD
Insert the cassette into deck 2 and follow these steps to change the
side.
® Press [TAPE DECK1/2] so the deck 2 indicator lights.
© Press [-^] then [■]. Tape direction will be shown as
How volume, sound quality/surround effect
recording
The tape you are recording is not effected whatsoever by changes
in volume, sound quality, suround effect and surround system.
In recording, sound quality, surround effect and surround system
are set automatically to “FLAT.
To erase a recorded sound Q
® Disconnect the microphone(s).
@ Press [TAPE DECK1/2].
(3) Insert the recorded tape into deck 2.
@ Press [DOLBY NR] so that the Dolby NR indicator goes off.
® Press [REV MODE] to select reverse mode.
(D Press [• REC/STOP].
•You cannot record when [6CH DISCRETE INPUT] is selected.
•You cannot open deck 1 while recording.
•You cannot fast-forward or rewind one deck while recording with
the other.