Panasonic SC-AK57 - Manual (Page 44)

Using th& timer
Using the iptay/record timer
If you set the timer incorrectly
Repeat the procedure from step Q.
To check settings
While the unit is on and the “Ф PLAY" (or “© REC") indicator is on,
press [CLOCK/TIMER] so "© PLAY” (or “© REC") appears on the
display.
Two seconds after “© PLAY” (or “© REC") appear, the settings are
displayed in the following order.
• For play timer
Ф Play start time
® Play end time
(5) Play source
eg) Playback volume
• For record timer
© Recording start time
(5) Recording end time
© Recording source
To enjoy the desired source after the timer setting is com­
pleted
The volume level and music source are stored in the timer memory
and the timer will start in these preset conditions. However the Disc
number, Dolby NR and reverse mode do not get stored in the timer
memory.
1. After step Q, turn on the unit and start playing the desired
source.
2. Reset the Disc number, Dolby NR and reverse mode if you have
changed any of them, confirm that a Disc or cassette is inserted,
then press [POWER] to put the unit on standby.
Turning the timer ON/OFF
One of the timers is on when the [® PLAY/® REC] button is alight.
When the unit is on (or off and in NORMAL mode) you can confirm
which is on by checking which indicator is on the display.
When the unit is off and in ECO mode, press [CLOCK/TIMER], The
display will then show which timer is on and the settings that have
been made (see above).
To change the timer, press [Ф PLAY/© REC].
Each time the button is pressed the setting changes as follows.
0 PLAY^ О REC^(off)
t____________________ I •
• If the power is on, the timer will not function. The system must be
in the standby mode.
• if you switch the power to the standby mode while the play/record
timer is functioning, the OFF time setting will not be activated.
• If "AUX1/2” or “6CH DISCRETE INPUT is selected as the source,
when the timer comes ON, the system will turn ON and will en­
gage "AUX1/2” or “6CH DISCRETE INPUT” as the source. If you
want to playback or record from a connected component, set the
component’s timer to the same time. (See the instruction manual
that came with the component.)
•The play timer cannot be used in combination with the record
timer.