Panasonic WV-BM1900 - Manual (Page 6)

1. Power Indicator
When turning on the Power On/Off Switch (2), this
indicator lights.
2. Power On/Otf Switch {POWER, ON/OFF)
This switch is used to turn on or off the power of
this monitor.
3. Scan Size Switch (SCAN SiZE UNDER/
NORMAL)
Underscanning is obtained by pressing this
switch.
8. Bright Control [BRIGHT]
Turn this control clockwise to increase the overall
brightness,
9. Focus Control [FOCUS]
Adjust for the clearest picture.
10. Contrast Control [CONTRAST]
Turn this control clockwise to increase the picture
contrast.
4. Horizontal Hold Control [H-HOLD]
This control is used to lock in the picture horizon­
tally.
5. Height Control [HEIGHT]
Adjust the vertical height of the picture,
6. Vertical Hold Control [V-HOLD]
This control is used to lock in ttie picture vertically.
7. Vertical Linearity Control (V-LIN)
Adjust for vertical distortion of the picture.
11. Video Input Connector (VIDEO IN)
This connector accepts the input video signal.
12. Video Output Connector (VIDEO OUT)
The video input signal connected to the Video
Input Connector (11) is looped through to this con­
nector.
13. Video Termination Switch (VIDEO 7512/HiZ)
When bridging or looping through the video signal,
set this switch to Hi-Z position, and for other cases
this switch should be set to 750 position.
-
4
-