Panasonic WV-BM1900 - Manual (Page 8)

CONNECTIONS
Power Cable
1. Keep the power of this monitor to the OFF position
during connection.
2. Connect the Power Cord to a 60F!z grounded elec­
trical outlet 120V AC.
Video Cable
Note:
• Always set the last monitor’s Video Termination
Switch to 75 ii, and set the Video Termination
Switch of Intermediate monitors to Fii-Z.
Camera Coax.
Cable
Monitor Monitor
.VIDEO ..... Coax.
Cable
© @ 0
© ® В
Use the RG-59/U (3C-2V), RG-6/U (5C-2V), RG-
11/U (7C-2V) or RG-15/U (10C-2V) coaxial cable.
Up to 10 monitors can be hooked up in this config­
uration before signal loss occurs. Total cable
length should not exceed 150m (500 feet)
2. Wiring Precautions :
• Do not bend coaxial cable into a curve whose
radius is smaller than 10 times its diameter.
• Never staple the cable - not even with circular sta­
ples,
• Never crush or pinch the cable.
All these will change the impedance of the cable
and cause poor picture quality.
External Sync
When a non-composite video signal is connected to
the monitor, it will be necessary to connect an external
composite sync signal to the monitor.
1
.
Connect the Sync Input Connector (17) on the
video monitor to the sync signal source by means
of a 75 Q coaxial cable.
Set the Sync Selector Switch (16) to the EXT posi­
tion.
SYNC
INT
У
3. The operation of Sync Termination Switch (19) is
the same as Video Termination Switch (13).
-
6
-