Panasonic RP WH20 - Manual (Page 3)

Operation
Preparation:
Turn on the equipment that you have
connected.
If you have connected the transmitter to the
headphones jack on the equipment, turn the vol­
ume up as far as possible without causing distor­
tion.
n Switch the transmitter on with
the OPR switch.
Turn the volume on the head­
phones all the way down, then
switch them on with the OPR
switch.
The OPR/BATT indicator lights up.
Put the headphones on and ad­
just the volume.
Since this unit utilizes an infrared beam, in pro­
portion to the range from the infrared beam trans­
mitter, hiss may increase. Interception of the
infrared beam causes noise or a break in
sound.
These phenomena are not an indication that the
unit is out of order.
• Use the headphones within the range described
in “Installation”.
• Obstructions decrease the effectiveness of the
sensor. Keep your hands away from the sen­
sors.
«This unit uses infrared beams, so do not use
the headphones in direct sunlight.
After use:
«Switch off the headphones, transmitter, and
audio-visual equipment.
«Store the headphones on the transmitter.