Cleaning, Temperature inside the printer, Condensation – Panasonic AGEP50 User Manual
Page 33: Conditions for condensation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cleaning
• For safety reasons, unplug the Printer's Power
Cable before cleaning.
•Wipe the cabinet and operation panel with a soft
cloth.
•When the Printer is very dirty, use a cloth
moistened with water and mild detergent, and
then wipe with a dry cloth.
•When using a chemical cloth, follow its
instructions.
Temperature Inside the Printer
•The internal temperature depends on the ambient
temperature and the Printer’s operation condition.
If the temperature rises above a certain level, the
[ERROR] Lamp flashes and the Error Message
“WAIT: COOLING” appears on the TV screen. In
this case, the Printer automatically stops printing
temporarily. This is not a malfunction. Wait for a
while (max. 4-5 minutes). As soon as the
temperature has dropped to a normal level,
printing will resume automatically.
•In the following cases, it may take considerably
more than 4-5 minutes until printing is resumed.
O When more than 10 prints are made in quick
succession.
0 When the surrounding temperature is high,
e
When the ventilation holes are blocked and the
temperature inside the unit builds up.
Therefore, be sure to place the Printer in a
well-ventilated location.
Condensation
When condensation has formed inside the Printer,
the [ERROR] Lamp flashes and the Printer cannot
be operated. In this case, leave the Printer on and
wait for approx. 2 hours. After the humidity inside
the Printer has returned to a normal level, it will
operate again.
•The first print made after condensation has been
cleared up may be blurred because the paper and
the roller may not yet be completely dry,
•As condensation forms gradually, it may take
about 10-15 minutes before the [ERROR] Lamp
flashes.
After a sudden change in the room temperature
and humidity, confirm that the [ERROR] Lamp
does not flash, before using the Printer.
•The cooling fan is automatically activated when
condensation has formed or the temperature
inside the Printer has risen above a certain level.
As soon as the condensation has been resolved
or the internal temperature has reached a normal
level, the cooling fan automatically stops.
Conditions for Condensation:
Condensation may form if the Printer or the Video
Print Set is brought to a place with very different
temperature and/or humidity.
•Places with much steam and high humidity.
•When rrioving the Printer or the Video Print Set
from a cold or air-conditioned room to a place with
high temperature and humidity.
•A room where the heater has just been turned on.
w
o
33