Panasonic AGEP50 - Manual (Page 34)

Cautions for Use
(Cont’d)
Printing Paper and ink Cassette
To reduce the risk of deterioration of the picture
quaiity or malfunction of the Printer, be sure to
observe the foilowing points:
■ Notes for Loading the Video Print Set
• Use only Video Print Sets bearing the “ "
logotype.
•To obtain optimum picture quality, use only the
Printing Paper and the Ink Cassette packed
together as a set in the same box.
• Be careful not to stain the ink film in the Ink
Cassette and the printing side of paper with
fingerprints. Do not write on the Printing Paper
before printing.
• Be careful that the Printing Paper and the Ink
Cassette do not become dusty before printing.
•The picture will be printed on the glossy side of the
paper (the side without any printed markings).
Be sure to load the paper with the glossy side
facing upward into the Printer. If loaded
incorrectly, printing is not possible.
• If the ink film in the Ink Cassette is loose, tighten it
by turning the spool in the direction of arrow
before loading.
• tf the Print Set was stored in a cool place, wait until
it has adapted to the room temperature, before
opening it.
•Do not let more than 10 prints accumulate at the
Print Exit. It could cause a paper jam.
• Do not print again on a finished print.
•Never use wet or bent Printing Paper or a wet Ink
Cassette.
■ Notes for Storing the Video Print Set
• Do not leave the Ink Cassette and Printing Paper
in places with high temperature and humidity for a
long time. It could cause inferior printing quality.
To store them, avoid high temperature and
humidity and return them into the bags in which
they were originally packed.
• Put the paper back into the original bag and store
it flat. If stored standing on its side, the paper
could become bent and warped, and this could
cause, paper jam during printing.
• Do not expose the paper to direct sunlight for a
long time. It could cause inferior picture quality.
■ Notes for Handling Finished Prints
• Do not stick adhesive tape to the printing side of
prints nor leave the printing side in contact with
vinyl products, plastic erasers, or similar objects.
This could cause discoloration, color transfer or
other damage to the prints due to chemical
reaction.
•Do not spray or spill any liquid containing thinner,
alcohol, etc. on the prints. This could cause
discoloration of the prints.
•Never leave the printing side of two prints in
contact with each other. This could cause color
transfer.
•Avoid storing the prints in places with high
temperature or humidity, or places exposed to
direct sunlight for a long time. This could reduce
the picture quality of the prints.
• If the prints are stacked and pressed together or if
they are left in contact with other paper for a long
time, some color transfer may occur.
•When storing the pictures in an album, it is
recommended to use one with transparent
pockets made of cellophane, nylon or materials
similar to nylon.
■ Other Cautions
•Unauthorized printing of copyrighted material for
commercial purposes is copyright infringement.
• If the Video Print Set has a defect or flaw caused
by the manufacturing process, it can be
exchanged for a new set of the same type. For any
other defects, however, the manufacturer shall not
be responsible.
The following two types of Video Print Sets can be
used with this Video Color Printer.
(Use only the specified Video Print Sets and Video
Print Ink Cassettes bearing the “ ” logotype.)
■ When Using the Optional Video Print Set
(VW-MPS50P) (50 sheets)
•Do not affix any stamps or labels to the Printing
Paper and do not write on the paper with a
typewriter, etc. before printing. This could cause a
paper jam.
•Do not write on the paper before printing.
•To write on the printing side of the paper after
printing, use a permanent marker (felt pen with
oil-based ink).
•Writing on the back side of the paper is possible
with felt pens with oil- or water-based ink, pencils,
bail-point pens, etc. Exerting strong pressure
when writing by hand may cause traces to remain
on the printing side.
■ When Using the Optional Video Print Set
(VW-MPSS25P) (25 sheets/set)
•Do not peel the backing (marked side) off the
adhesive paper before printing. This could cause
a paper jam.
•Before attaching the print, wipe dust and dirt from
the surface (paper, glass, plastic, metal, etc.) of
the object where it is to be attached.
•When cutting out part of a print to use as adhesive
label after printing, use a single-sheet cutter and
cut with the backing still attached.
34