Там interface trouble (in auto switching mode), Tam interface trouble (in fax mode) – Panasonic Panafax UF-311 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ТАМ Interface Trouble
(in Auto Switching Mode)
TAM Interface Trouble
(in Fax Mode)
Symptom
Action
Cannot utilize the remote
turn-on feature of the
telephone answering
machine. The fax machine
always answer after
8
rings.
This feature is not compatible. The fax machine is
designed to answer after 8 rings if TAM does not
answer.
Fax machine will not start
up when the telephone
answering machine is set
to give only an outgoing
message (OGM).
TAM with outgoing message (OGM) only is not
compatible. The fax machine will work with a TAM
that will record Incoming Message (ICM).
A beep... beep sound is
recorded on the
telephone answering
machine.
Speak a little slower between each word while
recording an outgoing message (OGM).
Fax machine starts up in
the middle of the
outgoing message even
though the caller wants
to leave a voice message.
Make sure the outgoing message (OGM) does not
have a silent pause longer than 3 seconds.
Cannot record any
incoming message (ICM).
The fax machine always
starts up at the end of the
OGM and before the tape
advances to the end of
last ICM.
If your TAM uses a single cassette tape to give OGM
and record ICM, set fax Parameter No. 12 to off (silent
detection).
However, you may not able to receive fax message
from machine that does not send CNG signal (a short
beep tone every 3 seconds).
Cannot receive from
machine that does not
send CNG signal (a short
beep tone every 3
seconds) after dialling.
Set fax Parameter No. 12 to on (silent detection).
Cannot retrieve message
from the answering
machine remotely, the fax
machine always starts up
after the command code
is inputted.
After the command code is inputted, press a digit on
the telephone keypad approx, every 2 seconds until
you start hearing your message. Select a digit that
does not correspond to any of the remote functions
of your telephone answering machine. Refer to your
answering machine's operation guide.
Cannot receive fax
message, but can record
voice message.
Check your outgoing message, if it is too long, the
catling fax machine may be time out. Try shorten your
outgoing message to less than 15 seconds, or ask the
calling party to program your telephone number in
their fax machine with 3 pauses and *#* at the end.
(ex. 555 1212 PAUSE PAUSE PAUSE #}
Fax machine will not start
to receive with the
telephone answering
machine in the auto
answer mode.
Increase the number of ringing detection on the
telephone answering machine.