Panasonic RX-DT670 - Manual (Page 9)

POWER SOURCE
■ Battery operation (ten R20/LR20)
Insert ten “R20/LR20" size (UM-1 or equivalent, not included) batteries into the battery compartment, making sure that the
batteries are installed in the designated numerical order and that the proper polarities are maintained.
•Battery life
The amount of light provided by the operation/battery check/
AC connection indicator is a good indication as to how much
longer the batteries can be used.
• Press the operation switch to turn on the unit.
When the operation/battery check/AC connection indicator
goes out or dims, replace all batteries with new ones.
\ i /
NORMAL
/ t \
I
^ REPLACE
Important note;
If you cannot open the cassette compartment cover and
eject the cassette tape when running this unit on batteries,
replace the batteries with new ones, or use the AC power
source, and then perform the operation once again.
•Battery removal
Remove as shown in the figure below.
UpperSh.l( iQèZ^CDCZ)
LowprsiHrit
(^CZXZZiCZ)
Bottom Shelf
о
prrm
i = b
■DC IN
•AC IN-
© (8]®(T0KT) 0
0 сю®®® ©
©(UQD©
■ AC power operation
Connect the included AC mains cord to the AC socket in the
unit and your household AC mains outlet.
•The operation/battery check/AC connection indicator will
light during AC mains operation.
AC power cord
AC power outlet
■>©
AC IN-
(Back of product)
Note:
To operate on battery power, unplug the AC mains
cord from the household AC mains outlet and the AC
socket on the unit.
■ Car Battery Operation
1. Insert the plug of the car battery cord into the DC Input
Jack.
2. Plug the other end into the cigarette lighter socket in your
car.
Upon plugging the car battery cord into the DC Input
Jack, the unit will automatically switch from internal
battery to car battery operation.
©
DC IN 13.2 V
(12-15 V)
Car battery cord
(not included)
0
^Cig
liah
Cigarette
lighter
socket