Panasonic PV-M2036 - Manual (Page 3)

Important Safeguards and Precautions
INTRODUCTION
Careful attention has been given to this Video product to assure
a quality standard devoted to your safety and enjoyment. This
quality standard together with your persona! responsibility for the
safety of yourself and others, wilt contribute to your enjoyment.
This Video product uses electrical energy and requires proper
handling at all times.
I
CAUTION
READ AND RETAIN THE SAFETY AND OPERATING INSTRUCTIONS
To make full use of the safeguards incorporated in this unit, read
and follow this basic guide, adopted in part from Underwriter's
Laboratories Standard 1409, Second Edition, before operating this
Video product.
FOLLOW THE INSTRUCTIONS AND BE SURE TO HEED ALL
WARNINGS on unit and in the manual, for easy maintenance,
proper and trouble free operation of this Video product.
INSTALLATION
1 .
A
2.
A
3.
A
4.
A
5.
A
6 .
A
OPERATE FROM A POWER SOURCE INDICATED on this
Video product, or in this Manual. Your Electric Utility Service
Company or Video Products Dealer will be happy to verify the
power source in your home.
THE GROUNDED OR POLARIZED PLUG IS A SAFETY FEATURE
This Video product may be equipped with either a polarized
2-wire AC line plug or a 3- wire grounding type plug. The two
wire polarized plug (having one blade wider than the other)
will fit into the power outlet only one way. If It is a three wire
grounding type plug (having a third pin), it will fit into a
grounding type outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE GROUNDED
OR POLARIZED PLUG by tampering with it. If the plug does not
fit fully into the socket, try reversing it. If you should still be
unable to fully insert the plug into the socket, you may find
that a proper outlet is needed to meet today's Electrical
Standards. An electrician will replace your outlet safely.
POWER SUPPLY CORDS SHOULD BE PROTECTED and
routed so that they are not likely to have anything rest on
them, roll over them, or be subject to walking traffic or abuse:
particularly at plug-ins, convenience receptacles, or cord exit
points from the unit. Where an extension is needed, use a
grounded or polarized cord.
HAZARDOUS FRAYED CORDS OR DAMAGED PLUGS
SHOULD BE REPLACED BY A QUALIFIED SERVICE
TECHNICIAN.
OVERLOADED WALL OUTLETS AND EXTENSION CORDS
PRESENT DANGEROUS RISKS OF FIRE OR ELECTRICAL
SHOCK.
AVOID BLOCKING VENTILATION HOLES
Your video unit has ventilation openings in its cabinet to
release heat generated during operation. Blocking these
opening can cause heat build-up inside the unit, causing
failure that may result in a fire hazard or heat damage to
cassettes. For protection:
a. Never cover the bottom ventilation slots or the unit with soft
material, or operate the unit placed on a bed, sofa, rug, or
soft accessory.
b. Avoid built-in installations, such as a bookcase or rack,
unless proper ventilation is provided.
AVOID EXTREMELY HOT LOCATIONS OR SUDDEN
CHANGES IN TEMPERATURE such as placing the unit near
or over a radiator, in direct sunlight, closed vehicles, or
transporting it suddenly between areas of
extreme temperature variation.
If the unit is suddenly moved from a cold place
to a warm place, moisture may form on the
tape and inside the unit.
TO AVOID INJURY TO A CHILD, ADULT; OR
COSTLY DAMAGE:
a. Do not place unsecured equipment on a sloping surface or
any heavy object or unit.
(Use the unit in a horizontal position and do not place
anything heavy on it.)
b. Support for the unit should be adequately firm, level, and
strong. Replace any unstable cart, table or support. An
appliance and cart combination should be moved with
care. Quick slops, excessive force, and uneven surfaces
may cause the appliance and cart combination to overturn.
c. Carefully follow all operating instructions and use the
manufacturer's recommended accessories when operating
this unit or connecting it to any other equipment.
OUTSIDE ANTENNA, EQUIPMENT, AND POWERUNE EXPOSURE
NEC - NATIONAL
ELECTRICAL CODE A
A
INSURE SAFE ANTENNA
AND CABLE CONNECTIONS
If an outside antenna or cable
system is connected to the
antenna
equipment, be sure the
DISCHARGE UNIT antenna or cable system is
(NEC SECTION HO-IO) j j grounded so as to provide
CONDUCTORS some protection against built
(NEC SECTION
up static charges and voltage
GROUND CLAMPS surges. Part 1 of the Canadian
POWER SERVICE Electrical Code, in USA
ELECTRODE SYSTEM Section 810 of the National
(NEC ABTi».PARTM, Electrical Code, ANSI/NFPA
70, provides information with respect to proper grounding of the mast
and supporting structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location of antenna
discharge unit, connection to grounding electrodes and requirements
for the grounding electrode.
ELIMINATE ANTENNA PROXIMITY TO HIGH VOLTAGE POWER
SOURCES, OR CHANCE OF ACCIDENTAL CONTACT BY INSTALLER
An outside antenna system should be located where it will never be
reached by power lines, electric light or power circuits and where it
will never contact these power sources if it falls. Installer should use
extreme care to avoid possible fatal contact by touching power lines,
circuits or other power sources when installing an outside antenna.
USE
A
2 .
A
AFTER STORING OR WHEN MOVING THE UNIT, REFER TO THE
INSTALLATION SECTION OF THE SAFEGUARDS.
1. DO NOT USE THIS VIDEO UNIT NEAR WATER: around bathtubs,
sinks, laundry, wet basement, swimming pool or any water source.
USE ACCESSORIES RECOMMENDED ONLY BY THE
MANUFACTURER to avoid risk of fire, shock or other hazards.
UNPLUG ALL EQUIPMENT EXPOSED TO RAIN, MOISTURE, OR
A STRONG IMPACT AND GET A QUALIFIED INSPECTION
If your unit has been exposed to rain, water, excessive moisture, or
subjected to strong impact, unplug it and have it inspected by a
service technician before use.
4. UNPLUG UNUSED UNIT, AND ALL EQUIPMENT DURING A STORM
A During a lightning storm, when indoors or outdoors, or before leaving
unit unused for extended periods of time, disconnect all equipment
from power source, antenna and cable system.
UNPLUG ALL EQUIPMENT BEFORE CLEANING. After unit has
A been unplugged use a dry, clean, chemically untreated cloth. Use no
cleaning fluids, aerosols, or forced air that could over-spray, or soak
into the unit, and cause electrical shock. Any substance such as wax,
adhesive tape, etc. may affect the cabinet surface. Exposure to
greasy, humid, or dusty areas may affect internal parts.
WHEN PLUGGED-IN: KEEP WATER AWAY; NO FINGERS INSIDE
A NOR ANY OBJECTS INSIDE; AND NO MAGNETS OR
ELECTRICAL INTERFERENCE NEARBY.
a. Never operate the unit if liquid has been spilled into it. Immediately
unplug the unit, and have it inspected by a service technician. Fire
and shock hazards can result from electrical shorts caused by
liquid contact inside.
b. Caution the children about dropping or pushing objects into the
unit. Some parts inside carry hazardous voltages and contact can
cause electric shock. Objects dropped in electrical equipment can
cause fire hazards.
c. Separate the unit from any interference causing appliances.
Placing the unit directly above or below your TV set may cause
electrical interference. Keep all magnets away from electronic
equipment.
3.
5.
6 .
SERVICE
A
2.
A
3.
A
DO NOT ATTEMPT TO SERVICE THIS PRODUCT YOURSELF. If
this Video product does not operate as described, when the
detailed Operating Instructions are followed, do not attempt to
open or remove covers, or make any adjustments not described in
the manual. Attempting to service this unit yourself may expose
you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.
CHECK ON REPLACEMENT PARTS REQUIRED. Be sure the
service technician has used replacement parts specified by the
manufacturer or having the same characteristics as the original
part. Unauthorized substitutes may resuit in fire, electric shock or
other hazards.
HAVE TECHNICIAN PERFORM SAFETY CHECK described in
the manufacture's service literature, after any service or repairs,
to determine that the Video unit is in safe operating order.