Panasonic PV-M2036 - Manual (Page 8)

On Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the Channel
number will appear for a few
seconds on-screen.
(Some station names may
also appear.)
When a function button is
pushed (PLAY, FF, etc.)
the Combination VCR
mode will be displayed.
• When a recording is started, both REC and
the channel will appear together.
Menu Screen
1 Push the MENU button to
display the menu.
2 Rotate and push the
wheel to make your
selection (see page 6).
08
MAIN f^NU
d|i| [Ml
oiom I
1^1 loi
№ CH O j DCK Si IT
SELECT : FtCTATE WHEEL
SET : PUSH WHEEL
Warning and Instruction Displays
These displays will alert you to a missed operation or
provide further instructions.
WNET If no active channels
' ■
N
NO CH FOUND
are found for CHANNEL
PLEASE CHECK ANTENNA
MEMORY... CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
<__________________________ ^
If a Timer Program was not
completed before exiting the
Program mode...
If you push the REC button on
the remote control or the REC
and PLAY buttons on the
Combination VCR, and a
cassette is inserted with no
record tab...
CHECK CASSETTE
RECORD TAB
• To get the most from each feature, it is
recommended that you read the Operation
Manual before attempting any operation.
VCR Status & Clock Display
Push the DISPLAY button to display and remove
the overlay shown below.
Function Status Time
Rec Time
Remaining
(OTR mode only
see page 15.)
Tape Counter
REC 12 : 00AM WNET-
~0: 25 0:00:00
^ SLP
Channel &
Call Letter
Tape Speed
If you push the STOP
button during a Timer
Recording...
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
If you push the PLAY, FF, REW,
or REC button on the remote
control or if you push the REC
and PLAY buttons, the FF,
PLAY, or REW button on the
Combination VCR without a
cassette inserted...
If you attempt to set or review
a Timer Recording or set the
On Timer and the Clock is
not set...
N0 CASSETTE
PLEASE INSERT A CASSETTE
PLEASE SET CLOCK
BEFORE PROGRAMMING
Blank Tape and will be Blue Screen
If a blank section of tape is encountered in the Play
mode or the channel you select has no broadcast,
the TV screen will change to a solid blue field.
The screen will remain blue until a recorded signal
is again detected or an active channel is selected.
Two minutes before a Timer
Recording is about to begin...
PLEASE prepare
FOR TIMER REC
8