Connecting an analog amplifier or system component, Connecting a digital amplifier or system component, Connecting an active subwoofer (optional) – Panasonic DVD-RV21 User Manual
Page 29: Recording to mds or cassette tapes, Analog recording, Digital recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting an analog amplifier or
system component
Connecting a digital amplifier or
system component
DVD-RV41 I DVD-RV31 |ШО-РУ26)
DVD-RV21
DVD-RV41 I DVD-RV31 |[РУОЖУ26]
DVD-RV21
Back of the unit
Back of the unit
insert fully, with
this side facing
up.
Amplifier or system component
•Select “2-channel” (• page 22). liVJiirWH
Adjust the settings to suit the equipment you have con-
•Select “No" in “PCM Down Conversion” page 26).
nected page 26).
k..
Si
S
iS
(U
E
5
To enjoy Dolby Pro Logic
• If you connect an amplifier with a Dolby Pro Logic decoder, you will also need to connect center and surround speakers to enjoy
surround sound. Read the instructions for the equipment for connection details.
•Turn Advanced Surround and Bass Plus off (» page 14). The Dolby Pro Logic decoder will not function correctly if Advanced Surround
or Bass Plus is on.
Connecting an active subwoofer (optional)
DVD-RV31
llD.yo;BM26)
DVD-RV21 I
You can enjoy more powerful bass by connecting an active subwoofer.
• Place the subwoofer as close as possible to the front center.
•Turn BASS PLUS on to boost the output from the subwoofer
(- page 14).
•Adjust the volume on the subwoofer to suit your preference.
Recording to MDs or cassette tapes
DVD-R V41 I DVD-RV31 IID.VD-R.V26]
_________ IDVD-RV211
■ Analog recording
You can record to an MD or cassette tape.
Using analog connection means sound will be unaffected by the
copy guards found on DVDs.
To make an analog recording
1. Connect the recording equipment with an audio cable Q
above).
2. Set "Speaker Setting" to “2-channel" page 22).
(If this is set to "Multi-channel", only the audio lor the front 2
speakers will be recorded.)
■ Digital recording
You can record the digital signal directly onto an MD.
The signals on DVDs will be converted to 48 kHz/16 bit linear PCM.
Ensure the following conditions are met.
•There is no copy guard recorded on the disc.
•The recording equipment can handle a sampling frequency of
48 kHz/16 bit.
To make a digital recording
1, Connect the recording equipment with an optical digital audio
cable Q above).
2. When recording DVDs, change the digital audio output settings
(- page 26).
PCM Down Conversion: Yes
Dolby Digital: PCM
I
DTS Digital Surround: Off
nQT5733