Panasonic RX-FT570 - Manual (Page 4)

Listen^ io Éadw Bro€bdcàst$
le 1111 II
Set SELECTOR to RADIO.
Set BAND to the desired radio
band.
FM STEREO: To receive FM
stereo broadcasts
(if you have tuned
into an FM stereo
broadcast, the FM
indicator wiil light.)
AM: To receive AM
broadcasts
if FM stereo reception is poor, set BAND to FM. This
will reduce the noise and provide ciear reception:
however, the broadcast wiil not be heard in stereo.
Use TUNiNG to tune into a
desired broadcast.
I
Adjust VOLUME, GRAPHIC
EQUALiZER and XBS.
iCliitLMOCHl nw
The radio can be turned off by setting SELECTOR to TAPE/
XBS (extra bass system) El
When the XBS button is set to "ON”, the dynamic low fre­
quency ranges are boosted. Adjust the level by using the
XBS level control. Using this system with graphic equalizer
helps you to get more dynamic sounds.
Graphic Equalizer Q
It allows you to edit the frequency response of the unit to
compensate for room acoustics and other factors which
affect frequency response. The overall tone can be altered
by adjusting the controls at the three frequency bands;
100Hz, 1 kHz, 10 kHz.
For increased amplification of the corresponding frequency
band, position the switch towards “+10” marking and like­
wise towards the “-10" marking to attenuate the correspond­
ing frequency band.
If the XBS button is set to “ON”, the 100 Hz control functions
as the XBS level control.
Adjust the antennas {0
FM;
Pull out the telescopic antenna and adjust its length and
angle for optimum reception.
AM:
Turn the unit in the direction which gives the best results.
FM
AM