Panasonic SL-PD1010 - Manual (Page 23)

Before requesting service for this unit, check the chart below tor
a possible cause of the problem you are experiencing. Some sim­
ple checks or a minor adjustment on your part may eliminate the
problem and restore proper operation.
If you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem, refer to
the directory of Authorized Service Centers (enclosed with this
unit) to locate a convenient service center, or consult your
Technics dealer for instructions.
Problem Probable cause(s) Suggested remedy
Changer will not play. A disc(s) or other foreign object{s) has fallen
inside the changer,
• Open the loading drawer, and then remove the
object.
Moisture has collected in the changer. • Switch on and allow the changer to dry out for about
one hour before using it.
The disc in the changer
does not play. The disc is upside down. • Make sure the label is facing upward.
The disc is dirty. • Wipe the disc with a soft cloth.
The disc is scratched. • Replace the disc with a new one.
The disc is warped.
The disc is not within specified standards.
Play stops before changing
to the next disc.
The loading drawer is open. • Press the OPEN/CLOSE button to close the loading
drawer.
A certain music passage
can’t be played correctly. The disc is dirty. • Wipe the disc with a soft cloth.
The disc is scratched. • Replace the disc with a new one.
There is noise from the
tuner or disturbance on the
TV screen. Caused by high-frequency signals from this
changer.
• Use the changer further away from the tuner or TV.
• If the tuner or TV's antenna is the indoor type, use an
outdoor one.
When program play Is
started, an error message
(-E) appears on the
display. Play was started without a track being
programmed. • Program a track.
An error message (- E)
appears on the display, and
the changer stops
operating. The mechanism of the changer has been
improperly adjusted. • Turn the unit off and then back on again.
However, if the loading drawer is fully open, take out
the compact disc(s) at the front position and then turn
the unit off and then back on again.
The loading drawer stops In
the middle of opening.
Remote control does not
operate correctly. The batteries have run out. • Replace batteries with new ones.
There is an obstruction between the remote
control and the changer. • Remove the obstruction.
The batteries are inserted incorrectly.
[The (+) and (-) polarities are reversed.] • Reinsert batteries so that the polarities are correct.
23