Panasonic SL-PD1010 - Manual (Page 4)

for mí^ff
Placement
Avoid placing the unit in areas of:
• direct sunlight
• high temperature
• high humidity
• excessive vibration
• uneven surfaces. {Place the unit on a flat leve! surface).
Such conditions might damage the cabinet and/or other compo­
nent parts and thereby shorten the unit's service life.
Ventilation
Place the unit in a weii ventilated position at least 10 cms away
from wall surfaces etc.
Stacking
Maintenance
Clean the cabinet, panel and controls with a soft cloth lightly
moistened with mild detergent solution.
Do not use any type of abrasive pad, scouring powder or solvent
such as aicchol or benzine.
Service
• Never attempt to repair, disassemble or reconstruct the unit if
there seems to be a problem.
A serious electric shock could result if you ignore this precau­
tionary measure,
• If a problem occurs during operation (the sound is interrupted,
indicators fail to illuminate, smoke is detected, etc) contact
your dealer or Authorised Service Center immediately.
• Disconnect the power supply if the unit will not be used for a
long time. Otherwise the operation life could be shortened.
Never place heavy items on top of the unit or the power cord.
Voltage
• It is very dangerous to use an AC power source of high voltage
such as for an air conditioner.
A fire might be caused by such a connection,
• A DC power source can not be used.
Be sure to check the power source carefully, especially on a
ship or other place where DC is used.
Power cord protection
• Avoid cuts, scratches or poor connection of the AC mains cord,
as this may resuit in fire or electric shock hazard.
Excessive bending, pulling or slicing of the cord should also be
avoided.
• Do not pull on the cord when you are disconnecting the power,
as this could cause an electric shock. Grasp the plug firmly
when you disconnect the power supply.
• Never touch the plug with wet hands or a serious electric shock
could result.
Foreign materials
• Ensure that no foreign objects, such as needles, coins,
screwdrivers etc, accidentally fall into the unit or through the
ventilation holes.
Otherwise, a serious electric shock or malfunction could occur,
• Be extremely careful about spilling water or liquid on/into the
unit, as a fire or electric shock could occur.
(Disconnect the power plug and contact your dealer immediate­
ly if this occurs.)
• Avoid spraying insecticides onto the unit as they contain flam­
mable gases which can be ignited.
•In secticides, alcohol, paint thinner and similar chemicals
should never be used to clean the unit as they can cause flaking
or cloudiness to the cabinet finish.
ЕШШЕШ
strong
Avoid places such as the following:
• Near any equipment or device that generates
magnetism.
• On any heat-generating equipment or device, or in any place
where the temperature is high (35° C or higher).
• Extremely cold place (5°C or below).
• Near a tuner or TV (It may cause noise in the broadcast, or
disturbance of the TV picture.).
When carrying or storing the unit, handle it with
care so it is not subjected to any strong bumps.
Always remove the discs before storing the unit for any period of
time.
To avoid problems due to vibration.
• Do not place a book or similar object under this unit.
• Do not route the connection cables (of this or other units)
across the operation panel, across the top, or under the unit.
Moisture may form on the lens in the following
cases...
• Immediately after a heater has been turned on.
• In a steamy or very humid room.
• When the unit is suddenly moved from a cold environment to a
warm one.
If moisture forms inside this unit, it may not work properly. In this
case, turn on the power and wait about one hour for the moisture
to evaporate.