On-screen displays (osd), Vcr status & clock display, Press display – Panasonic Combinatin VCR AG-513E User Manual
Page 36: To display or remove the overlay, Blue screen display, Channel & function display, Warning and instruction displays, Osd caution page
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
On-Screen Displays (OSD)
VCR Status & Clock Display
to display or remove the overlay.
(See pages 28, 29.)
Rec Time Remaining
(OTR mode only,—
see page 14.)
CH 08 ABC MOVIE
(See page 4.)
Time Stamp Data (See page 31.)
Blue Screen Display
Whenever a blank section of a
tape comes up in Play mode, or
when the selected channel has no
broadcast signal with the Weak
Signal Display Feature set to
“OFF” (see page 30), the screen
will turn solid blue.
Channel & Function Display
When a function button is pressed
(PLAY, FF, etc.) or you change
channels, the unit mode or channel
number will be displayed. (Some
station names may also appear if
Channel Caption is set. See pages
28 and 29.)
Warning and Instruction Displays
These displays will alert you to a missed
operation or provide further instructions.
NO CH FOUND PLEASE CHECK
ANTENNA CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
• If no active channels are found for CHANNEL
PLEASE SET CLOCK BEFORE
• If you attempt to set or review a Timer Recording,
or set the On-Timer and the Clock is not set...
CHECK CASSETTE RECORD TAB • If you press REC, and a cassette is inserted with
no record tab...
TO CANCEL TIMER REC HOLD DOWN
STOP KEY FOR APPROX 3 SEC
• If you press STOP during a Timer Recording...
• If you press PLAY, FF, REW, or REC without a
PLEASE PREPARE FOR TIMER REC
• If the unit is not in Stop mode or a cassette with
record tab is not inserted two minutes before a
Timer Recording is about to begin...
VIDEO HEADS MAY NEED CLEANING
PLEASE INSERT HEAD CLEANING
CASSETTE OR REFER TO MANUAL
END: PLAY KEY
• If head cleaning becomes necessary while
playing back a tape...
VCR LOCK ACTIVATED
* If you press a function button other than STOP/
EJECT or POWER while the unit is in VCR Lock