Panasonic Cx-dp88u - Manual (Page 15)

Installation Guide
□ Precautions
If possible, this product should be professionally installed. In case of difficulty, please consult with your nearest
professional installer.
1. This Product operates only in a 12-volt DC negative ground system.
2. Before performing installation and wiring, remove the negative (-) terminal of the battecy. (See note below.)
Note: Do not disconnect the negative battery terminal in vehicles with trip or navigational computers.
All electronic memory settings previously registered will be lost. Take extra care to avoid short circuiting
when installing the unit.
3. Follow the wiring connections diagram carefully to avoid causing damage to the unit.
4. Insulate all exposed wires to prevent short circuiting.
5. Secure all loose wires after installing the unit.
6. First, connect the extension cord O (supplied) to the CD changer and then, connect RCA pin connectors
and the extension cord 8p DIN connector to the CD/Cassette Receiver. Finally, connect the battery lead
(yellow) to a constant power supply.
7. Please carefully read the operating and installation instructions of any equipment connected to this unit.
8. Press the reset switch with a sturdy and pointed object when any operations do not function. If the unit does
not become restored even after pressing the reset switch, contact your nearest Panasonic Servicenter for
service.
□ Supplied Hardware
Description Q’ty
o
Hex. Bolt with Double Washers (M4 x 8 mm) 4
o
Base Bracket 2
e
Hex. Nut (M5) 4
o
Mounting Bracket (L) 1
0
Mounting Bracket (R) 1
0
Double-Faced Adhesive Tape 2
0
Extension Cord 1
CX-DP88U
15