B to seiect stereo or monaural fm q, Automatic memory scan (for memo mode), B automatic tuning (for free mode) – Panasonic RQ-SX50V User Manual
Page 5: Note, S-xbs, Train, Listening caution, Care and use, When using overseas, Troubleshooting guide
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Listening to the radio
Care and Use
■
To
obtain
better
reception
When
listening
to
AM
broad
casts: E
As the built-in ferrite antenna is
used, try various directions to ob
tain optimum reception.
When
listening
to
FM
broad
casts;
As the cord of the earphones acts
as the FM antenna, extend it as far
as possible rather than leaving it
coiled.
B
To
seiect
stereo
or
monaural FM Q
Press and hold SOUND SEL (main
unit) or the button © (remote con
trol) during FM reception.
When there is noise during FM
reception:
Select “MONO".
The sound becomes monaural, but
noise is reduced.
When using overseas
■ Automatic memory scan
(for MEMO mode)
After selecting a band, press and
hold
-I-
or - until the frequency dis
played begins to scroll on the main
unit.
This function allows you to listen to
each of the broadcast stations
stored in the memory, for about
5 seconds in order.
When a broadcast you like is
being received;
Press -f or - again.
To release the scan:
Press — AUTO on the main unit.
B Automatic tuning
(for free mode)
When selecting a broadcast fre
quency, press and hold -i- or -
until the frequency displayed be
gins to scroll on the main unit. It
automatically stops when a station
is located.
To stop automatic tuning:
Press -f or - again.
(Available only from the main unit)
Allocations need to be changed ac
cording to the area.
1. Press RADIO/BAND to switch
on the power.
2. Press RADIO/BAND for more
than 5 seconds to display the
step.
3. Press -f or - to select the step.
Each press changes the indica
tion to “FM U0.2”, “FM UO.r or
"E".
"FM U0.2” (original setting):
FM 0.2 MHz,
AM 10 kHz
“FM U0.1”:
FM0.1 MHz,
AM 10 kHz
“E”;
FM 0.05 MHz,
AM 9 kHz
4. Press and hold MODE to con
firm the step. The display shows
the lowest AM frequency.
To return to the previous fre
quency step:
Repeat the steps above.
Note:
Converting
the
frequency
step
erases
the
stations
previously
stored in the memory.
To Change the Tone
is)
NOR:
Cancels the EQ effect. Normal sound.
S-XBS:
Boosts the low frequency range.
• If distortion occurs, turn down the volume.
TRAIN:
Cuts down the audible level of sound which may disturb those around you.
•Avoid using or placing this unit near
sources of heat. Do not leave it in an
automobile exposed to direct sunlight
for a long period of time with the doors
and windows closed.
•To avoid product damage, do not ex
pose this product to rain, water or
other liquids.
Rechargeable battery and charger
•Use only the included charger when
recharging.
•During recharging, it is normal for the
charger and the rechargeable battery
to become slightly warm.
• Do not leave the charger turned on for
more than 12 hours at one time, other
wise the rechargeable battery life may
be shortened.
•Avoid
recharging
or
placing
the
rechargeable battery near sources of
heat or humidity.
• Do not peel off the plastic covering ori
the rechargeable battery. Short-circuit
ing may result which is dangerous.
• In order to derive the maximum from
the battery’s continuous operating
time, allow it to run down completely
before recharging it,
•The included rechargeable battery can
be recharged about 300 times.
After that, its operation time shortens
and the rechargeable battery should
be replaced.
Dry cell battery and rechargeable
battery
• Load the new battery with their polari
ties (© and ©) aligned correctly.
• Do not apply heat to batteries, or inter
nal shortcircuit may occur.
• If this unit is not to be used for a long
period of time, remove the batteries
and store them in a cool and dry place.
• Remove spent batteries immediately.
Listening caution
Do not play your headphones or ear
phones at a high volume. Hearing ex
perts advise against continuous extend
ed play.
If you experience a ringing in your ears,
reduce volume or discontinue use.
Do not use while operating a motorized
vehicle. If may create a traffic hazard
and is illegal in many areas.
You should use extreme caution or tem
porarily discontinue use in potentially
hazardous situations.
Even if your headphones or earphones
is an open-air type designed to let you
hear outside sounds, don’t turn up the
volume so high that you can’t hear
what’s around you.
Sound can be deceiving. Over time your
hearing "comfort level" adapts to higher
volumes of sound. So what sounds “nor-
mai” can actually be loud and harmful to
your hearing.
Guard against this by setting your equip
ment at a safe level BEFORE your hear
ing adapts.
To establish a safe level:
•Start your volume control at a low
setting,
•Slowly Increase the sound until you
can hear it comfortably and clearly,
and without distortion.
Once you have established a comfort
able sound level:
•Set the dial and leave it there.
To product you have purchased is powered by a nickel-cadmium
battery which is recyclable.
Please call 1-800-8-BATTERY for information on how to recycle
this battery.
Troubleshooting Guide
Before requesting service for this unit, check the chart below for a possible cause of
the problem you are experiencing. Some simple checks or a minor adjustment on
your part may eliminate the problem and restore proper operation.
If you are in doubf about some of the check points, or if the remedies indicated in the
chart do not solve the problem, refer to the directory of Authorized Service Centers
(enclosed with this unit) to locate a convenient service center, or consult your dealer
for instructions.
For detailed Instructions, contact an authorized servicenter 1-800-211-7262 or
web site (
Symptom
Checkpoint
No operation possible.
Has the HOLD mode been released?
Remote control fails to
work properly.
Have the earphones and remote control plugs
been connected.?
No sound is heard.
A cracking noise is
heard.
Are the plugs clean?
• No reception.
•The FM frequency
range is different.
Has the frequency step been set for your area?