Ieriwqilime, When to replace the agitator, How to replace the agitator – Panasonic MC-V7375 User Manual

Page 18: To replace the agitator, Replacing the agitator, Agitator assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

iERiWQiliMe

1. When to replace the agitator.

The agitator should be replaced when the brushes
are worn. Brushes should be checked by holding a card
across the lower plate, see illustration. If the bristles on

the agitator

DO NOT

touch the card, you

SHOULD

replace the agitator for best cleaning results.

2. How to replace the agitator.

Place the vacuum cleaner handle in the upright position.

See the HANDLE ADJUSTMENTS section. Remove the lower
plate as outlined in the REMOVING/INSTALLING THE LOWER
PLATE section. After the lower plate is removed, carefully lift up the agitator until it clears both

sides of the nozzle housing. While holding the agitator up, remove the belt.

NOTE:

The two brush supports may come off along with the two washers as you lift the agitator

out.

DO NOT

lose the two small washers. Look at the exploded view of the agitator below for

correct assembly of the parts.

3. To replace the agitator.

Place the belt over the belt pulley on the brush unit.

NOTE:

There is a place for the belt to fit on

one end of the agitator only. Replace both washers and brush supports, see illustration below for

correct assembly. After assembling the belt, washers and brush supports place the agitator back
into the nozzle housing by aligning each brush support.

After completing the assembly, rotate the brush, turning it by hand to assure that
it rotates smoothly and the part Is assembled correctly.

Replace the lower plate as outlined in the REMOVING/INSTALLING THE LOWER PLATE section.

AGITATOR ASSEMBLY

Brush Support

Washer

Belt Pulley

Brush Unit

Brush Suf^ort

-

18

-

Advertising