Panasonic MC-V7375 - Manual (Page 20)

REMOVING CLOGS
The hose located on the back of the vacuum cleaner carries the dirt from the nozzle
up to the dust bag. If the hose should become clogged:
1. Unplug the power cord from the outlet
before checking the airflow passages. Pull
open the suction inlet cover and check for
clogging in this area.
Cover
(Suction
Inlet)
2. Disconnect the wand from the short hose
and check the wand and hose for clogging.
Plug in the vacuum cleaner and turn it on.
While running the vacuum cleaner with the
wand disconnected, stretch the hose in and
out to remove the clog.
3. If the clog still exists, turn the vacuum
cleaner OFF and unplug the power cord. Turn
the vacuum cleaner over, exposing the under­
side. Remove the lower plate. Remove the
short hose from the housing by lifting it
straight up. Inspect the hose end and clear it
of any obstructions. Reinstall the short hose
and lower plate. See the REMOVING/
INSTALLING THE LOWER PLATE section for
detailed instructions.
-
20
-