Rightline Gear Cargo Saddle Bag - Manual

1-Clean the back of your vehicle, unscrew your license
plate and place it inside the Cargo Saddlebag’s interior
license plate sleeve (Fig 7).
2-Load the Cargo Saddle-
bag on the ground. The load
capacity of the carrier is
~100 lbs. Don’t exceed the
load rating of your vehicle’s
attachment points.
1-Loop the (2) long side straps around the vehicle’s lug-
gage rack; either the rear cross bar or the (2) side rails.
If using the rear cross bar (Fig10), it may be necessary to
move the cross bar towards the rear of the vehicle. If using
the side rails (Fig11) run each strap from the inside to the
outside of each rail.
Assemble The Bottom Pole Frame
Attach The Carrier - WITH A Roof Rack
Attach The Carrier - WITHOUT A Roof Rack
Cargo Saddlebag Set Up Guide
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 1
Fig 2
Fig 10
Fig 3
Fig 11
Fig 7
Continue with the section titled “Adjusting The Main Straps”.
1-Run (2) of the poles through the pole guides into the
sewn pole pockets (Fig 2).
3-Run the remaining (2)
poles through the Velcro
pole pockets, through the
pole guides and into the
junctions (Fig 4).
4-Make sure the individual segments of the pole frame
are firmly locked together by checking the pole buttons
(Fig 5).
5-Fold the Velcro closures over the ends of the (2) pole
pockets (Fig 6).
Sewn
Pole
Pockets
Velcro
Pole
Pockets
Pole Guides
Pole Guides
Cross Pole/Junction
Assembly
Fig 4
Fig 5 Fig 6
2-Attach the cross pole/junction assembly onto the ends of
these poles (Fig 3).
Pack The Carrier
1-Open the vehicle’s rear hatch door just enough to run
the belt strap around the inside of the door. Make sure
the strap is not twisted. Hold the (2) strap ends tight and
close the door over the strap. Let the (2) strap ends hang
down (Fig 8).
2-Attach the Cargo Saddlebag to the vehicle per the
instructions in the following sections. Buckle the belt strap
around the carrier. Tighten the belt strap by adjusting the
tri-glide (Fig 9).
Attach The Belt Strap*
1-Add the Rightline Gear Saddlebag Car Clips (Fig 12)
(sold separately) to the long side straps (Fig 13). Please
see the Saddlebag Car Clips directions for more detail.
Fig 8
*The belt strap is optional if you attach the bottom straps
to your vehicle (see “Attach The Bottom Straps”).
Tri-glide
Buckle
Fig 9