Rightline Gear CampRight Truck Tent User Manual

Rightline Gear Sports and recreation

Advertising
background image

1-

With the tailgate down, place the tent in your truck bed

with screen mesh side facing up. Slip the tailgate pocket

and under-strap over the end of the tailgate (Fig 1).
2-Attach the black strap clips to the bottom outside lip of

the truck and snug up the straps slightly (Fig 2).

3-Run all (4) tent poles through their matching color coded

sleeves (Fig 3).

5-Attach the inside green and red straps to your truck bed

corner tie down points/cleats (Fig 5). Notice (2) straps at-

tach to each cleat.

Position the rain fly over the tent. Place the cab access

sleeve from the tent inside the cab access sleeve of the

rain fly (Fig 9 & 10). Attach the buckles and adjust their

straps as necessary (Fig 11). Use of the rain fly is optional.

Truck Tent Set Up Guide

6-Adjust the inner and outer straps until the seam where

the inner flap meets the tent runs along the top outside

edge of your truck bed (Fig 8).

CAUTION:

Each CampRight truck tent is designed to

fit all makes and models of trucks within its category.

The tents will fit slightly tighter on the largest size truck

and slightly looser on the smallest size truck within their

category. For those tents that feel tight during initial in-

stallation, please use caution when tightening straps and

placing poles into pole pockets. Do not use excessive

force when performing these steps.

CAUTION:

Do not drive with the tent set up. Do not run

the truck engine when anyone is inside the tent. Please

read and observe the caution tag on the inside of the

tent.

If your truck does not have tie down points, clip the (2)

front red straps together (Fig 6) and run the (2) rear green

straps through the tailgate gap to attach to something be-

low (Fig 7). With this option, the middle (2) red and (2)

green straps will hang free.

Fig 1

Fig 2

Fig 3

Fig 4

Fig 5

Fig 6

Fig 7

Fig 8

Fig 11

4-Raise the (2) gray center poles by inserting the pole

ends into their matching color coded pockets (Fig 4). Then

raise the green and red poles. Make sure the pole sleeves

slide over the poles with no hang-ups - don’t force the

poles through.

Once you have the straps adjusted for your truck, the next

set-up will go faster.

Fig 9

Fig 10

Setting Up The Truck Tent

Using The Rain Fly

Advertising