Reset switch, Figure 3-3 – Windy Nation Xantrex C Series Multifunction DC Controller User Manual
Page 81
Reset Switch
975-0004-01-02 Rev D
61
Reset Switch
Use the Reset Switch on the side of the chassis for the
following conditions.
•
To manually initiate battery equalization in Charge
Control mode, press and hold the Reset Switch until the
red and green LED start to flash.
•
To manually suspend battery equalization in Charge
Control mode, press and hold the Reset Switch until the
red and green LED stop flashing.
•
To reset following an error condition, press and release
the Reset Switch.
•
To reset following a low-voltage disconnect, press and
release the Reset Switch.
See
for additional information
about reconnecting to loads.
Important:
The LED will light red only in Load Control
mode; never in Charge or Diversion mode (unless it is reversed
upon reinstallation).
Figure 3-3 Reset Switch
Reset Switch