MagnaFlow AUDI TRUCK Q5 Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 2)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1. Start by removing the O2 sensors from the
pipe behind the resonator. Loosen the OEM clamp
behind the resonator. Disengage the exhaust hangers
from the rubber insulators (Save the insulators and
clamp as they will be re-used on the new system), and
remove the exhaust system.
Step 2. Begin installation of your new MAGNAFLOW
exhaust system by attaching the Y-Pipe Assembly to
the resonator outlet using the OEM clamp. Insert the
hanger into OEM rubber insulators and re-install the O2
sensors.
Step 3. Then install D/S Muffler Assembly in a similar
fashion as the Y-Pipe assembly using the supplied
2.50" clamp and inserting the hanger into the OEM
rubber insulaters.