Harbor Freight Tools Model 65903 - Manual (Page 14)

SKU 65903 For technical questions, please call 1-800-444-3353. Page 14
SidE ViEW ENd ViEW
FiGuRE i
SCREW
(30)
SCREW
(30)
SCREW
(30)
7. Loosen four Screws (30) which hold Motor (14) in place. Then, slide Motor toward
Large Belt Wheel to loosen tension on V-Belt (27).
(See Figures H and i.)
Remove loose V-Belt (27) from Large Belt Wheel and Motor Pulley (14).
8.
(See Figure H.)
Install a new V-Belt (27) on Large Belt Wheel and Motor Pulley (14).
9.
(See Figure H.)
MOTOR PuLLEY
(14)
LARGE
bELT WHEEL
3/4”
V-bELT
(27)
FiGuRE J
10. Slide the Motor (14) back toward its original position to tighten the tension on the
V-Belt (27). NOTE: To determine the proper tension on the V-Belt, with your index
finger press down on the V-Belt. The V-Belt should deflect downward about 3/4”.
If necessary move the Motor Pulley (14) toward or away from the Large Belt Wheel
until the V-Belt deflects downward 3/4”. Then, retighten the four Screws (3) to se-
cure the Motor (14) in place. (See Figures i and J.)