Harbor Freight Tools Model 65903 - Manual (Page 6)

SKU 65903 For technical questions, please call 1-800-444-3353. Page 6
sor parts when the unit is connected to electrical power. Always have compressor
safety guards in place before turning compressor on.
use approved air hose
13. . Never use plastic or PVC pipe (unless specified for Air
Compressors) to carry air under pressure. Regardless of its pressure rating, it can
burst under pressure. Use only metal pipe.
Never plug the power cord of this product into an electrical outlet while
14.
standing on a wet or damp surface.
THiS AiR COMPRESSOR MAY REquiRE A dEdiCATEd ELECTRiCAL CiR- 15.
CuiT AS THE AMPERAGE dRAW uNdER FuLL LOAd, COMbiNEd WiTH uSE
OF ANY OTHER iTEM, MAY OVERLOAd YOuR CiRCuiT.
Always turn off the Air Compressor in the event of a power failure. 16.
Performance of this Air Compressor may vary depending on variations in lo- 17.
cal line voltage.
Maintain labels and nameplates on the Air Compressor.
18. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a replace-
ment.
19. WARNiNG! People with pacemakers should consult their physician(s) before
using this product. Electromagnetic fields in close proximity to a heart pacemaker
could cause interference to or failure of the pacemaker.
20. WARNiNG! The brass components of this product contain lead, a chemical
known to the State of California to cause birth defects (or other reproductive harm).
(California Health & Safety code § 25249.5, et seq.)
21. WARNiNG! The warnings, precautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the opera-
tor.
SAVE THESE iNSTRuCTiONS
GROuNdiNG
1. WARNiNG! The Power Cord (31) requires the attachment of a 240 volt,
grounded, 3-Prong Plug (not included). For safety purposes, only a qualified,
certified, electrician should attach a Plug to the Power Cord. Never modify the
Plug in any way. To comply with the National Electric Code, and to provide addi-
tional protection from the risk of electrical shock, this product should only be con-
nected to a 240 volt electrical outlet that is properly grounded.
do not use the tool if the Power Cord or Plug is damaged.
2. If damaged, have it
repaired by a qualified service facility before use.