360 Systems Short/Cut Editor - Manual (Page 34)

Page 26 Editing
360 Systems
Location Marks
Points of interest may be noted with the M ARK key at any time. These Location Marks
are indicated by a small tick above and below each waveform display as shown in the figure
below:
L
R
SHORTCUT PROMO 0:00.00
WAVEFORM DISPLAY SHOWING LOCATION MARKS ON BOTH TRACKS
Location Marks are not the same thing as the Edit Marks, and are used solely to mark a
location so it can be quickly found in the future. Most Edit operations leave Location Marks to
assist in finding past edit positions.
The A RM buttons determine on which track the Location Marks will be placed. In stereo
operation, a pair of tick marks will appear above and below the two waveform displays.
Marks are always tied to the audio they are associated with, and not to a time reference.
If a single track is edited, two marks beyond that edit may become displaced from each other;
and in the case of deletion, a mark may disappear along with its audio. Deleting a segment of a
File does not slip the marks with respect to audio.
The G O T O keys will quickly "tab" to the next Mark on any armed track. This feature can
be used to advantage. When many Marks have been placed, "disarming" both tracks will limit
the search to only five places: Start of File, the Zero Mark, Edit-In mark, Edit-Out mark, and
End of File. By selectively arming tracks an entirely different set of Location Marks can be
placed on each of the two tracks.
A Location Mark may be removed by locating to it (with the G O T O keys) and pressing
M ARK again. The Mark symbol will disappear. A range of marks may be removed by
highlighting an area containing the marks, holding the U NDO key, and pressing M ARK .
The Zero Mark
Zero Mark allows you to specify a point in the file you are editing that you can
immediately re-locate to. It does not affect the Time Display or the start point of playback in
the Files Display.
The Zero Mark is distinguished as a small triangle at the bottom of the waveform display,
just below where the triangle at the bottom of the Cursor is displayed. It is initially set to the
beginning of the file. A single Zero Mark always exists in every file.
To set the Zero Mark, hold M ARK and Press the “0” H OT K EY . You can do this while in
any Edit playback mode. (Note that if done “on the fly” during playback or recording, a
conventional Mark will be also be placed at the point where you initially press M
ARK .)