360 Systems Short/Cut Editor - Manual (Page 64)

Page 56 Using Menus
360 Systems
Copy File or Directory
A File may be copied within a Directory, or from its original location to a new
destination Directory on the Internal or External disk. The target Directory must be set to the
same Sample Rate as the source directory or file Select a File or Directory, then select COPY
FILE. You can also select a File and press the C OPY key. The display shows:
SELECT DESTINATIO N DRIVE
(INTERNAL)
AND PRESS 'ENTER' TO CO NTINUE
The center line showing the INTERNAL Drive in this example can be changed to
EXTERNAL if an External Drive is connected. Press the A RROW K EYS or rotate the S CRUB
W HEEL until the desired destination Drive appears then press E NTER to confirm the selection.
The display then shows:
SELECT DESTINATIO N DIRECTO RY
(PUBLIC DIRECTO RY)
AND PRESS 'ENTER' TO CO NTINUE
The center line showing the Public Directory in this example can be changed to indicate
any other Directory. Rotate the S CRUB W HEEL until the desired destination Directory appears,
then press E NTER to confirm the selection. A Directory may also be selected using the
N UMERIC K EYS to enter the Directory number; a "0" (zero) or "P" may be used for the Public
Directory.
If a single file is being copied, the display now prompts for a new name for the File;
however, it is not necessary to change the existing name when copying to a different Directory.
ENTER DESTINATIO N FILE NAM E
____________________________
PRESS 'ENTER' TO CO PY
Upon pressing E NTER , the file will be copied, unless there is already a file with the
specified name in the destination directory. If there is a duplicate, the display will prompt for
another file name for the copy.
If a Directory is being copied, there is a choice of how to handle duplicate filenames
should any be encountered during the copy operation. The display will show:
REPLACE FILES WITH THE SAM E NAM E?
PRESS ‘ERASE’ TO REPLACE FILES
PRESS 'ENTER' TO SKIP FILES