Aviom A-16R/A-16CS - Manual (Page 40)

31 A-16R P
eRsonAl
M
ixeR And
A-16Cs C
ontRol
s
uRfACe
u
seR
G
uide
Use these steps to create a second and/or third Group.
Select a channel that is • not currently part of an existing
Group.
Press the
• G
Roup
button to enter Group Mode. The Group
LED will flash.
Double‑click any channels that you want to add to the
•
Group.
To save the Group, press the
• G
Roup
button again. The
flashing LED will go out.
Shortcut: While in the Group edit mode, you can start the process of creating
a new Group while editing an existing Group. To do this,
Press a channel button that is not already part of the •
current Group being edited. Its red LED will light solid.
Double‑click channels to add them to a new Group.
•
Create a third Group by following the same procedure. •
Exit the Group edit mode to save the Groups. •
Save the Preset. •
If you try to create more than three Groups, the interface will automatically
select one of the existing Groups when you enter Group edit mode. You have
the option at this point to edit an existing Group or clear channels that are
part of one of the other existing Groups.
P N
ote
: A channel that is already part of one Group cannot be part of any
other Group.
Making Changes to a Group
Once you have created a Group, you can edit it in a number of ways. You
can add or delete channels from the Group, and change individual channel
volume and pan settings.
To change a Group,
Select a channel that is already part of a Group. •
All channel LEDs that are part of the Group will light. •
Press the • G
Roup
button to enter the editing mode.
The Group LED flashes. •
Changing Channel Settings Within a Group
While editing a Group, you’ll notice that one LED in each Group is lit solid
while the other LEDs are flashing. This solid LED indicates the channel
currently selected for editing. You can change its volume and panning