Barcus Berry 1460-N12 - Manual (Page 12)

BARCUS BERRY FAS-JAC ENDPIN JACK INSTALLATION:
TOOLS RECOMMENDED FOR FAS-JAC INSTALLATION
• One 16” to 18” (40cm-46cm) length of 1/4”(6.4mm) diameter
rod (e.g. wooden dowel)
• One 5/16”(8mm) screwdriver
• One 9/16” open end wrench or adjustable crescent wrench
PROCEDURE
1) Remove label, if any, from body of Fas-Jac
2) Unscrew and remove end cap from Fas-Jac
3) Remove end pin from guitar and drill 1/2”(12.7mm) through
end block where Fas-Jac is to be installed
4) Insert the 1/4”(6.4mm) diameter rod into the guitar through the
hole in the end block until visible through the soundhole
5) Push the rod into the Fas-Jac and gently pull