BUCHI Vacuum Pump V-710 - Manual (Page 39)

6 Operation
39 V-700/710 Operation Manual, Version E
6 Operation
This chapter explains the operating elements and possible operating modes. It gives instructions on
how to operate the instrument properly and safely.
ATTENTION
Check the glassware for damages prior to each operation and use only glassware in perfect condi-
tion. Glassware with cracks, stars or other damages can break during operation.
6 .1 Starting the pump
6 .1 .1 Pump without controller
After the pump is completely installed it is ready to operate, i.e. when the mains switch is pressed, the
pump starts operating right away and starts evacuating until the end vacuum (10 mbar with the V-700
and 2 mbar with the V-710). When the pump is operated continuously over a longer period of time it
automatically switches to the ECO² Mode (see chapter 4.5). In case the Vacuum Pump V-700 or V-
710 is part of a central lab source pump we recommend to use the Vacuum Module V-802 LabVac to
ensure an unreduced suction power during the whole operation time (see chapter 4.4).
6 .1 .2 Pump with controller
After the pump and the controller are completely installed, the system is ready to operate. When the
mains switch is pressed, the pump is on standby and starts operating as soon as the controller is
started. It then evacuates to the vacuum preset at the controller.
6 .1 .3 EasyVac
For a description of the EasyVac function, see chapter 4.3.
6 .1 .4 LabVac
For a description of the LabVac function, see chapter 4.4.
6 .1 .5 ECO 2 Mode
For a description of the ECO 2 Mode, see chapter 4.5.