Checkline DT-209X - Manual (Page 19)

15
The memory location where the measurement will be
stored is shown on the Unit and Measurement
section of the LCD display. (“M” followed by the
number indicates memory location inside the
current block).
The memory number will advance automatically as
the memory button is pressed each time.
The tachometer will stop advancing once 10 memory
values are stored (10 memory values per block). To
store additional readings the Power Switch is released
then pressed again until the number behind “M”
changes. It will show a FULL indicator on the LCD
display once 10 readings are stored.
When the memory, mode and units of measure
display indicator is not flashing, the tachometer stops
taking readings. Make sure that the Measurement
Power button is pressed while measuring.
Display Explanation