Checkline DT-209X - Manual (Page 68)

Measured value is divided by 2
There are two versions of the DT-209X,
Standard Version DT-209X is set for 6 inch
circumference wheel, and DT-209X-S12 is set
to 12-inch circumference wheel. Check the
front label for proper wheel attachments.
While storing values it shows "CCCCC"
The memory button was pressed for 5
seconds.
Could not measure Yards, feet, inches and meters per
minute These linear rate measurements are availab
in cont le
act mode using the wheel attachment.
Could not measure length
These measurements are available in contact
mode, using the wheel attachment.
Check battery orientation and reinstall.
Check the trig the table immediately.
Different USB port. For every USB port that
will be used, the USB driver is required to be
installed.
Brand new batteries no display.
While using the software, could not see values stored on
ger setting values.
Found new hardware icon appears every time the DT-
209X is plugged in to the computer. (Even after previous
installation of USB driver was successful.)
64