Checkline MESURgauge - Manual (Page 11)

User’s Guide
3.6 Test Units
Note: Reading and setting units is possible with Mark-10 gauges
only.
Select Units
The gauge’s unit of measurement can be set by clicking on
the appropriate selection from the drop-down menu.
SET
Sets the gauge to the units of measurement selected.
READ
Reads the unit of measurement to which the gauge is cur-
rently set.
Units Read
Displays the unit of measurement to which the gauge is
currently set.
3.7 Travel Port
This is a second COM port from which data from a travel display is
received. Travel readings are tabulated and plotted vs. load, as op-
posed to time vs. load.
Enable
Check this box to enable the second COM port for travel
data collection. The settings for this port can be configured
in the Port Configuration tab.
Invert Travel
Check this box to invert the polarity (sign) of the readings
from the travel display.
3.8 Pass / Fail Limits
Check this check box to enable high and low indicators for go / no
go type testing. When checked, Pass, Fail High, and Fail Low indi-
cators appear in the Acquisition tab, below the STOP button.
3.9 Folders
Enter full paths or browse for folders to use for Test Data (*.log) and
10